Table of Contents
Advertisement
4358-4805B US onBoard 35
11/22/10
3.
4.
5.
6.
41
3:26 PM
Page 43
Hook LATCH to Vehicle
LATCH Anchor
Fasten one LATCH belt hook
to the anchor in the vehicle
seat located in the vehicle
seat bight. Repeat for other
side of child restraint.
Tighten LATCH Belt
Push down firmly on the base
and pull up on the free end of
belt to tighten.
Check LATCH Belt
Tightness
Grasp the base at the belt
path with one hand. Push
and pull the base from side
to side, forward and back.
The base should not move
more than 1 inch.
NOTE: If base moves more
than 1 inch, try reinstalling
the base or try another
seating location.
To Attach Carrier to Base
Align the notches in the
front of carrier with the base
lock bar. Push down firmly
to lock. You will hear a
"click" when it is locked.
Pull up on carrier to make
sure it is locked.
Failure to securely attach carrier to base can
result in serious injury or death.
7.
Check for Proper
Recline
Check the angle indicator.
The ball should be
between the two marks on
the indicator that matches
the weight of your child.
Adjust base if needed. (see
section C-2 or read below).
NOTE: Check the angle
indicator while parked on
level ground.
You may need to place a
large rolled towel(s) or foam
pool noodle(s) under the front
of the base to achieve correct
recline angle. Check often to
be sure padding is still in
place and the belt is tight.
DO NOT add a towel or pool
noodle while the optional
footrest is being used.
8.
To Remove LATCH Belt
From Vehicle Anchor
Remove carrier from
base. Press down firmly
on the base on the side
with the LATCH adjuster.
Press release button to
release tension. Unhook
LATCH from bar by
squeezing spring lever
and twist hook.
42
Advertisement
Table of Contents
