Table of Contents
Advertisement
4358-4805B US onBoard 35
11/22/10
E-4 Installing Base with Vehicle Belts
Do not use the LATCH system along with the
vehicle lap or lap/shoulder belt. Store LATCH
belts when using the vehicle belts.
Check the vehicle belt before each use. Use only
if the belt is tightened properly and securely.
Failure to follow these warnings can result in
serious injury or death.
1.
2.
3.
43
3:26 PM
Page 45
Store LATCH Belts
You MUST store the LATCH
system when using the
vehicle seat belts. See
section D-7.
Place Base in Vehicle
Rear-Facing
Center the base in the
chosen seating position.
Thread Vehicle Belt
Thread the vehicle lap or
lap/shoulder belt
combination through belt
path as shown.
With an ALR belt, pull the
belt all the way out before
threading the base.
5.
Tighten Vehicle Belt
Push down firmly on the
base and pull up on the
shoulder belt to tighten
6.
Check Vehicle Belt
Tightness
Grasp the base at the
belt path with one hand.
Push and pull the base
from side to side, forward
and back. The base
should not move more
than 1 inch.
NOTE: If base moves more
than 1 inch, try reinstalling
the base or try another
seating location.
7.
To Attach Carrier to Base
Align the notches in the
front of carrier with the base
lock bar. Push down firmly
to lock. You will hear a
"click" when it is locked.
Pull up on carrier to make
sure it is locked.
Failure to securely attach carrier to base can
result in serious injury or death.
44
continued on next page.
Advertisement
Table of Contents
