Safety Instructions For Maintenance; Assembly; To Assemble The Guide Bar And Saw Chain - Husqvarna 120 Mark II Operator's Manual

• Do not start the engine if you spill oil or fuel on
the product or on your body.
• Do not start the product if the engine has a leak.
Examine the engine for leaks regularly.
• Be careful with fuel. Fuel is flammable and the
fumes are explosive and can cause injuries or
death.
• Do not breathe in the fuel fumes, it can cause
injury. Make sure that there is a sufficient airflow.
• Do not smoke near the fuel or the engine.
• Do not put warm objects near the fuel or the
engine.
• Do not add the fuel when the engine is on.
• Make sure that the engine is cool before you
refuel.
• Before you refuel, open the fuel tank cap slowly
and release the pressure carefully.
• Do not add fuel to the engine in an indoor area.
Not sufficient airflow can cause injury or death
because of asphyxiation or carbon monoxide.
• Tighten the fuel tank cap carefully or a fire can
occur.
• Move the product at a minimum of 3 m (10 ft)
from the position where you filled the tank before
a start.
• Do not put too much fuel in the fuel tank.
• Make sure that a leak cannot occur when you
move the product or fuel container.
• Do not put the product or a fuel container where
there is an open flame, spark or pilot light. Make
sure that the storage area does not contain an
open flame.
• Only use approved containers when you move
the fuel or put the fuel into storage.
• Empty the fuel tank before long-term storage.
Obey the local law on where to dispose fuel.
• Clean the product before long-term storage.
• Remove the spark plug cable before you put the
product into storage to make sure that the engine
does not start accidentally.
WARNING: Read and understand the
safety chapter before you assemble the
product.
To assemble the guide bar and saw
chain
1. Move the front hand guard in the direction of the
front handle to disengage the chain brake.
2. Fold the knob out to open position.
654 - 002 - 12.04.2018

Safety instructions for maintenance

• Disconnect the spark plug before doing
maintenance on the product, not including
carburetor adjustments.
• Have all product servicing done by an approved
dealer, not including the tasks in
on page 16 .
• Make sure the saw chain stops moving when the
throttle trigger is released.
• Keep the handles dry, clean, and free from oil or
fuel mixture.
• Keep caps and fasteners correctly tightened.
• Replacement components that are not approved
or the removal of safety devices can cause
damage to the product. This can also cause
possible injury to the operator or bystanders.
Only use accessories and replacement parts as
recommended. Do not change your product.
• Keep the saw chain sharp and clean for safe and
high performance.
• Obey the instructions for lubricating and
changing accessories.
• Examine the product for damaged parts. Before
more use of the product, make sure the
damaged guard or part operates correctly.
Examine for broken or incorrectly aligned parts,
and parts that do not move freely. Examine for
other conditions that can have an effect on the
operation of the product. Make sure the product
is correctly installed. A guard or other damaged
part must be repaired or replaced by an
approved dealer unless written in the operator's
manual.
• When not in operation, keep the product in a dry,
high or locked area away from children.
• During transportation or storage of the product,
use a guide bar cover or case to move the
product.
• Do not use waste oil. Waste oil can be
dangerous to you and can cause damage to the
product and environment.

ASSEMBLY

MAINTENANCE
9