To Lubricate The Cutting Equipment; To Do A Check Of The Saw Chain Lubrication; Transportation; Storage - Husqvarna 120 Mark II Operator's Manual

4. Tighten the guide bar nuts using the combination
wrench and lift the tip of the guide bar at the
same time.
• Empty the fuel and chain oil tanks before
transportation. Discard used fluids correctly.
• Put the guide bar cover on the cutting attachment
during transportation. This prevents persons from
touching the sharp saw chain by accident. A saw
chain not in operation can cause injury to you or
other persons that touch a sharp saw chain.
• Always put the product away safely when not in
operation. Leakages and fumes from the product
can touch sparks, naked flames from electrical
equipment, electrical mowers, relays/switches,
boilers and more.
• Always save fuel in an approved container.
654 - 002 - 12.04.2018
5. Make sure that you can pull the saw chain round

To lubricate the cutting equipment

To do a check of the saw chain lubrication

Do a check of the chain saw lubrication each time
you refuel.
1. Start the product and let it run at 3/4 speed. Point
2. After 1 minute of running, a line of oil shows on
3. If you cannot see the line of oil after 1 minute,
4. Start the product and let it run at 3/4 speed. Point
5. After 1 minute of running, a line of oil shows on
6. If you cannot see the line of oil after 1 minute,

TRANSPORTATION

•
•

STORAGE

•
•
freely by hand and that it does not sag.
the nose of the guide bar at a light color surface
almost 20 cm (8 in) away.
the light surface.
clean the oil channel in the guide bar. Clean the
groove in the edge of the guide bar. Make sure
the guide bar nose sprocket turns freely and that
there are no blockages in the lubrication hole.
Clean and lubricate the tip sprocket.
the nose of the bar at a light color surface almost
20 cm (8 in) away.
the light surface.
speak to your approved dealer.
Remove the spark plug cap from the spark plug
and engage the chain brake before
transportation.
Make sure the product cannot move during
transportation.
Empty the fuel and chain oil tanks when the
product is in storage for longer periods of time.
Discard used fluids correctly.
During storage, put the guide bar cover on the
guide bar. This prevents persons from
accidentally touching the sharp saw chain. A saw
21