VTech VSP600 Quick Start Manual page 13

IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at
1 (888) 370-2006
or call .
2. 7KH SRZHU DGDSWHU LV LQWHQGHG WR EH FRUUHFWO\ RULHQWHG LQ D YHUWLFDO RU ÀRRU PRXQW
position. The prongs are not designed to hold the plug in place if it is plugged into
D FHLOLQJ XQGHUWKHWDEOH RU FDELQHW RXWOHW
Battery installation and charging
Install the battery as shown on the following page. Once you have installed the battery,
the screen indicates the battery status (see the table below). If necessary, place
the handset in the charger to charge the battery. For best performance, keep the
handset in the charger when not in use. The battery is fully charged after 11 hours of
continuous charging.
If the screen is blank, you need to charge the handset without interruption for at least
30 minutes to give the handset enough charge to use the telephone for a short time.
When the battery is low, the handset shows Low battery DQG D ÀDVKLQJ .
Battery indicators
The screen is blank or The battery has no or
shows Place in charger little charge. The handset
and ÀDVKHV
cannot be used.
The screen shows Low Battery has enough charge
battery and ÀDVKHV to be used for a short time.
Full battery icon ( ) Battery is charged.
appears. The screen
shows HANDSETx [
represents the handset ID
number 1 to 6).
businessphones.vtech.com
Battery Status
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery
charged, place it in the
charger when not in use.
13
Action