VTech VSP600 Quick Start Manual page 10

To install the base station:
1. Plug one end of the Ethernet cable into the Ethernet port on the rear of the base
station (marked by ), and plug the other end of the cable into your network
router or switch.
2. ,I WKH EDVH VWDWLRQ LV QRW XVLQJ SRZHU IURP D 3R(FDSDEOH QHWZRUN URXWHU RU VZLWFK
a. Connect the supplied power adapter to the base station power jack.
b. Plug the power adapter into an electrical outlet that is not controlled by a wall
switch.
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at
businessphones.vtech.com
2. 7KH SRZHU DGDSWHU LV LQWHQGHG WR EH FRUUHFWO\ RULHQWHG LQ D YHUWLFDO RU ÀRRU PRXQW
position. The prongs are not designed to hold the plug in place if it is plugged into
D FHLOLQJ XQGHUWKHWDEOH RU FDELQHW RXWOHW
To mount the base station on a wall:
1. Install two mounting screws on the wall. Choose screws with heads
larger than 5 mm (3/16 inch) in diameter (1 cm / 3/8 inch diameter
PD[LPXP  7KH VFUHZ FHQWHUV VKRXOG EH  FP   LQFKHV
apart vertically or horizontally.
2. Tighten screws until only 3 mm (1/8 inch) of the screws
DUH H[SRVHG
Use only
Supplied
Adapter
RESET
1 (888) 370-2006
or call .
10