Final Operations - Smeg PGFA95F-1 Instructions For Installation And Use Manual

Smeg range instructions for installation and use
Table of Contents

Advertisement

Instructions for the installer

5. FINAL OPERATIONS

Having carried out the above adjustments, reassemble the appliance
following, backwards, the instructions in paragraph "4.2 Burner and
nozzle characteristics table".
After adjustment to a different kind of gas from the one for which the
cooker has been tested, replace the plate inside the heating
compartment with one corresponding to the new kind of gas. This plate
can be obtained from your nearest Authorised Assistance Centre.
5.1
Light the burner and take it to the minimum.
Remove the gas tap knob and turn the
adjustment screw inside or at the side of the tap
shaft (depending on the model) until there is a
regular minimum flame. Replace the knob and
check burner flame stability: (rapidly turning the
knob from maximum to minimum position, the
flame should not go out). Repeat the operation on
all the gas taps.
5.2
With time it may happen that the gas taps get blocked and hard to turn.
Clean them inside and re-grease them. This operation must be done
by a specialised technician.
16
Adjustment of minimum for natural gas
Lubrication of gas taps

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PGFA95F-1 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents