Advertisement
b. Default password: raritan (or a new password if you
have changed it).
5. If prompted to change the default password, change or
ignore it.
To change it, follow onscreen instructions to type your
new password.
To ignore it, simply press Enter.
6. The # prompt appears.
7. Type config and press Enter.
8. To configure network settings, type appropriate
commands and press Enter. Refer to the following
commands list. CLI commands are case sensitive.
9. After finishing the network settings, type apply to save
changes. To abort, type cancel.
Commands for network settings:
The <ipvX> variable in all of the following commands is
ipv4
ipv6
either
or
, depending on the type of IP protocol you
are configuring. Replace the <ETH> variable with the word
'ethernet'.
General IP settings:
To set or
Use this command
enable
network <ipvX> interface <ETH>
IPv4 or IPv6
enabled <option>
protocol
<option> =
network ipv4 interface <ETH>
IPv4
configMethod <mode>
configuration
method
<mode> =
network ipv6 interface <ETH>
IPv6
configMethod <mode>
configuration
method
<mode> =
network <ipvX> interface <ETH>
Preferred host
preferredHostName <name>
name (optional)
<name> = preferred host name
network dns resolverPreference
IP address
<resolver>
returned by the
DNS server
<resolver> =
Static IP configuration:
Raritan PXE Quick Setup Guide
QSG-PXE-1C-v3.5.0-E 255-80-0007-00 RoHS
true
, or
false
dhcp
(default) or
static
automatic
static
(default) or
preferV4
or
preferV6
To set
Use this command
network <ipvX> interface <ETH>
Static IPv4 or
address <ip address>
IPv6 address
<ip address> = static IP address, with a
syntax similar to the example below.
Example:
network <ipvX> gateway <ip address>
Static IPv4 or
IPv6 gateway
<ip address> = gateway's IP address
network dns firstServer <ip
IPv4 or IPv6
address>
primary DNS
server
<ip address> = DNS server's IP address
network dns secondServer <ip
IPv4 or IPv6
address>
secondary DNS
server
<ip address> = DNS server's IP address
network dns thirdServer <ip
IPv4 or IPv6
address>
third DNS
server
<ip address> = DNS server's IP address
To verify network settings:
After exiting the above configuration mode and the # prompt
re-appears, type this command to verify all network settings.
show network
QS Rule
Appendix B: Other Information
MAC Address
A label is affixed to the product, showing both the serial
number and MAC address.
If necessary, you can find its IP address through the MAC
address by using commonly-used network tools. Contact your
LAN administrator for assistance.
Identifying the Sensor Port
Warning: If you purchase Raritan's environmental sensor
packages, make sure you connect them to the correct port
on the PXE, or damages may be caused to PXE and/or
connected sensor packages.
192.168.7.9/24
5
Advertisement
