Mitsubishi MOTORS CARISMA 1996 Service Bulletin page 159

www.WorkshopManuals.co.uk
26-16
B.J.
MD998814
MD998817
Socket
8
FRONT AXLE - Drive Shaft
REASSEMBLY SERVICE POINTS
A DYNAMIC DAMPER/DAMPER BAND INSTALLATION
! ! ! ! " " " "
(1) Install the dynamic damper in the position shown in the
illustration.
Items
1600-A/T (L.H.),
1800-A/T (L.H.)
1600 (R.H.),
1800-A/T (R.H.)
1800-M/T (L.H.)
A11M0027
1800-M/T (R.H.)
(2) Using the end pliers, tighten the boot band.
B T.J. BOOT <L.H.> INSTALLATION
! ! ! ! " " " "
Using the special tool, install the T.J. boot <L.H.>.
C T.J. BOOT BAND INSTALLATION
! ! ! ! " " " "
Using the end pliers, tighten the boot band.
MD998812
A11U0088
D SPIDER ASSEMBLY INSTALLATION
! ! ! ! " " " "
(1) Apply the specified grease furnished in the repair kit to
the spider assembly between the spider axle and the
roller.
Specified grease: Repair kit grease
Caution
1. The drive shaft joint uses special grease. Do not
2. If the spider assembly has been cleaned, take
(2) Using the socket of 24 mm width across flats, install the
spider assembly.
A11U0088
Purchased from www.WorkshopManuals.co.uk
A
240±3 mm
369±3 mm
264±3 mm
264±3 mm
mix old and new or different types of grease.
special care to apply the specified grease.
<Added>
B
-
-
-
369±3 mm