Table of Contents
Advertisement
1
On the standby screen
w (1 second or longer)
Public mode is set and "
appears.
When you receive a call, the
caller hears the message "I can't answer the call
because I am driving or I have to refrain from
using a mobile phone now. Please call back later".
■ To release Public mode (Driving mode)
On the standby screen w (1 second or
longer)
Public mode is released and "
N
The Public mode setting takes priority even when
"Record message" is "ON".
The Public mode setting takes priority when
Manner mode is set at the same time.
If you make an emergency call (110, 119 or 118)
while Public mode is set, Public mode is released.
The following tones do not sound in Public mode:
• Ring tone for voice call/videophone/PushTalk
• Ring tone for mail and message
• Various alarm tones
• Wake-up tone
• Open-Close sound
• Charge sound
• Software tone for i-αppli
• Ring tone for packet communication/64k data
communication
• Search request notification tone for GPS
● When Public mode (Driving mode) is
set
The ring tone does not sound when a voice call,
videophone call or PushTalk call arrives. Calls are
logged as "Missed calls" in "Received calls", and the
"Missed call" desktop icon appears on the standby
screen.
A voice caller hears a message that you cannot
answer the call because you are driving or in the
place where you have to refrain from using a
mobile phone, and then the call ends.
A videophone caller sees the Public mode video
message on his or her display, and then the call
ends.
An incoming PushTalk call is not answered.
A PushTalk caller sees the "Connection failed"
message on his or her display. In a conversation
between three or more people, the participating
members will know that you are driving.
When you receive mail, the ring tone does not
sound and the "New mail" desktop icon appears on
the standby screen.
"
When Public mode (Power OFF) is set, a caller who
" disappears.
made a call while the power is off hears a message
that you cannot answer the call because you are in a
place where you have to turn off the mobile phone (in
a hospital, on an airplane, around a priority seat on a
train, etc.), then the call ends.
● When Public mode (Power OFF) is set
The setting is valid until "*25250" is dialed to release
Public mode (Power OFF). The setting is not released
by simply turning on the power.
The Public mode (Power OFF) announcement is
played even when you are out of service area or
where the reception is very poor.
N
If the power is off or "
announcement for "
Public mode message even when Public mode is
set. However, in case of PushTalk, "Disconnected"
appears on the members' displays.
Using Public Mode (Power OFF)
1
On the standby screen
w25251 r
Public mode (Power OFF) is set (Nothing
changes on the standby screen).
When you receive a call after setting Public
mode (Power OFF) and turning off the power,
the caller hears the message "The person you
are calling is in an area where mobile phones
should not be used. Please call back later".
■ To release Public mode (Power OFF)
On the standby screen
w25250 r
■ To check the Public mode (Power OFF)
setting
On the standby screen
w25259 r
A voice caller hears a message that you cannot
answer the call because you are in a place where
you have to turn off the mobile phone, and then the
call ends.
A videophone caller sees the Public mode (Power
OFF) video message on his or her display, and
then the call ends.
An incoming PushTalk call is not answered. A
PushTalk caller sees the "Connection failed"
message on his or her display. In a conversation
between 3 or more people, the participating
members will know that you are not participating.
" is displayed, the
" is played instead of the
<Public mode (Power OFF)>
19
Advertisement
Table of Contents
