Signode 257080 Operation, Safety And Parts Manual

Strap tensioner

Download this manual

STRAP TYPE

Dymax, Contrax, Tenax

Refer to Signode Operation, Parts & Safety Manual part number 186006

for additional part removal & replacement details and information.

IMPORTANT - DO NOT DESTROY THIS MANUAL. It is the customer's responsibility to have all operators

and service personnel read and understand this manual. Contact your local Signode representative for

additional copies of this manual.

ST-D TYPE STRAP TENSIONER

Part No. 257080

TOOL SPECIFICATIONS

WIDTH

1/2" (12.7mm)

PLEASE NOTE:

THICKNESS

.015"(0.38mm) to .030"(0.76mm)

Page 1 & replacement details and information. IMPORTANT - DO NOT DESTROY THIS MANUAL. It is the customer's responsibility to have all operators and service personnel read and understand this manual. Contact your local Signode representative for additional copies of this manual.
Page 2 Several combinations of strap, seals and tools can be used breakage during tensioning, which could with this tensioner. Use the correct Signode products for your result in the following: application. If you need help contact your Signode Representative.
Page 3 OPERATING INSTRUCTIONS Hold sealing tool at right angles to strap, resting it Wear safety glasses which conform to ANSI Standard squarely over seal. Seal the tensioned strap by bringing Z87.1 or EN 166. sealer handles together as far as they will go. Always position yourself to one side of the strap while tensioning and sealing.
Page 4 * Apply one drop of Loctite #271 (Red) or equivalent, available as Signode Part No. 422796. NOTE: Keys numbers 8, 34 and 35 can be ordered together as Gear Housing Kit, Signode part No. 424436. All parts must be periodically inspected and replaced if worn or broken. Failure to do this can affect a product's operation and can result in personal injury.

St-d series