Signode ST series Operation

Strap tensioner

Download this manual

STRAP TYPE

Apex, Magnus

Refer to Signode Operation, Parts & Safety Manual part number 186006

for additional part removal & replacement details and information.

IMPORTANT - DO NOT DESTROY THIS MANUAL. It is the customer's responsibility to have all operators

and service personnel read and understand this manual. Contact your local Signode representative for

additional copies of this manual.

ST TYPE STRAP TENSIONER

Part No. 003480

TOOL SPECIFICATIONS

WIDTH

3/8"(9.5mm) to 3/4"(19.0mm)

PLEASE NOTE:

THICKNESS

.015"(0.38mm) to .025"(0.63mm)

Need help?

Do you have a question about the ST series and is the answer not in the manual?

Page 1 & replacement details and information. IMPORTANT - DO NOT DESTROY THIS MANUAL. It is the customer's responsibility to have all operators and service personnel read and understand this manual. Contact your local Signode representative for additional copies of this manual.
Page 2 Several combinations of strap, seals and tools can be used breakage during tensioning, which could with this tensioner. Use the correct Signode products for your result in the following: application. If you need help contact your Signode Representative.
Page 3 OPERATING INSTRUCTIONS Snap a seal on the straps directly in front of the tool, making sure that the seal covers both straps. Wear safety glasses which conform to ANSI Standard Z87.1 or EN 166. Always position yourself to one side of the strap while tensioning and sealing.
Page 4 Signode Part No. 422796. NOTE: Keys numbers 8, 27 and 28 can be ordered together as Gear Housing Kit, Signode part No. 424436 All parts must be periodically inspected and replaced if worn or broken. Failure to do this can affect a product's operation and can result in personal injury.

003480