Tripp Lite B126-1P1M-U-POC Owner's Manual page 6

Troubleshooting
7. Are any patch panels or other devices installed between the
transmitter and receiver units? Tripp Lite's HDMI over Cat5 Extender
Kit was designed to be connected directly from the transmitter to the
receiver via UTP cable. The more connection points between the source
and the remote monitors, the more likely signal degradation will occur,
causing poor performance. If a patch panel or other device is between
the transmitter and receiver units, it should be removed from the
installation.
8. Is a splitter, switch or other device installed between the video
source and transmitter, or between the receivers and displays?
Tripp Lite's HDMI over Cat5 Extender Kit was designed for the
transmitter to connect directly with the video source and for the receiver
to connect directly to the display. If a splitter, switch, or other device is
between the video source and transmitter or between the receiver and
display, it should be removed from the installation.
9. Check your cabling for any damage that may have occurred during
installation. If a cable connector is loosened from pulling through
ceilings/walls or if the cable jacket is damaged, causing the wiring to be
exposed, you will not be able to achieve maximum performance.
10. Are the transmitter and/or receiver units located in an area
that exposes them to elevated temperatures? If the product is
overheating, it will not function properly.
17-01-160-9336A1.indb 6
6
2/22/2017 2:52:48 PM