Zodiac Jandy AquaLink RS R04685 Series Instructions

Main power center board (PCB) Replacement Kit
FOR YOUR SAFETY: This product must be installed and serviced by a professional pool/spa service technician.
The procedures in this instruction sheet must be followed exactly. Ensure that all electrical power to the system
is turned off before approaching, inspecting or troubleshooting any leaking valves that may have caused other
electrical devices in the surrounding area to get wet. Failure to do so could result in an electrical hazard which
could result in death or serious injury due to electrical shock, and may also cause damage to property. Improper
installation and/or operation will void the warranty.
These instructions are to be used with the following Jandy Replacement Kits:
R04685xx -- AquaLink RS Upgrade Assembly
R05865xx -- Aqualink PDA Upgrade Assembly
R0466700 -- AquaLink RS & PDA Main Power Center Board Assembly
R04668xx -- AquaLink RS, CPU Board
R05861xx -- Aqualink PDA, CPU Board
If the information in these instructions is not followed exactly, an electrical fire or shock hazard may result
causing property damage, personal injury or death.
1. Introduction
This document gives instructions for replacing
the PCB and the CPU of the Jandy AquaLink Power
Center. Before starting this procedure, use the parts list
of each kit to identify the parts that are in your kit.
If any parts are missing from the kit, please call
your local Jandy distributor for assistance. For technical
assistance, please contact our Technical Support
Department at (800) 822-7933.
These instructions must be followed exactly.
Read through the instructions completely before starting
the procedure. Please save these instructions.
Jandy AquaLink
®
RS & AquaLink PDA
®
WARNING
WARNING
2. Replacement of the Main Power
Center Board (PCB)
Risk of Electric Shock which can result In
Serious Injury or Death. Before attempting
installation or service, ensure that all power to the
circuit supplying power to the system is disconnected
or turned off at the circuit breaker.
All wiring must be done in accordance with the
National Electric Code
Canada, the Canadian Electrical Code (CEC),
CSA C22.1, must be followed. All applicable local
installation codes and regulations must be followed.
1. Before replacing the main power center board, go
to the Controller and review the current settings.
Then record all settings on the Programming and
Settings Worksheet provided at the back of these
instructions.
2. Turn off all power to the power center.
3. Open the door to the power center.
WARNING
(NEC ), NFPA 70 . In
® ® ®