Yamaha PW45 Original Instructions Manual page 89

INSTRUMENT AND CONTROL FUNCTIONS
2 Power supply to external devices
Power can be supplied to most external devices (e.g. vari-
ous smart phones etc.) by connecting a commercial USB
cable.
[To supply power]
1. Open the USB receptacle cap of the switch.
2. Connect the USB cable to the switch and external de-
vice.
3. Turn on the power of the vehicle.
[To stop the power supply]
1. Turn off the power of the vehicle.
2. Disconnect the USB cable and put on the cap of the
USB receptacle.
• Do not apply unreasonable force on the USB plug
or pull the USB cable.
• Check that the USB plug is facing the right way and
not totally out-of-position with the USB receptacle
or slanted, and make sure it is fully inserted all the
way in.
• Do not connect the USB receptacle and the USB
plug in a wet state.
• Use a USB cable that conforms to the standards.
• Do not insert foreign objects into the USB recepta-
cle unit.
Otherwise the display unit and external device may
malfunction.
TIP
• Power is supplied automatically when an external de-
vice is connected with the USB cable.
• No power is supplied if the remaining capacity of the
battery pack is low.
• The power supply of the vehicle will go off and power
supplied by the USB connection will also stop if the ve-
hicle is not operated for 5 minutes.
20
English - 69