LaserLiner DampMaster Manual page 18

14 Material temperature compensation
Relative material moisture is dependent on the
temperature of the material. The device automati-
cally compensates different material temperatures in
that it measures ambient temperature and uses this
measurement for its internal calculation.
However, the measuring device also offers an option
for setting the temperature manually (see Step 14b)
to increase measuring accuracy. This value is not
stored and must be set again each time the device is
switched on.
LCD backlight
15
LED display illumination can be varied with 3 different
settings:
AUTO: Display illumination switches off during
periods of inactivity and switches on again automati-
cally for measurement procedures.
ON: Display illumination remains on permanently.
OFF: Display illumination remains off permanently.
The setting is stored and remains in effect until it is
changed manually.
16 Temperature units of measure setting
The units of measure for ambient temperature and
material compensation can be set to either °C or °F.
The setting is stored and remains in effect until it is
changed manually.
18
GB
14b
1 sec
1 sec
3x
MODE
1 sec
4x
MODE
+
–
°C / °F