Toro 29517 Operator's Manual page 32

Changing the Engine Oil
Service Interval: After the first 5 hours
Every 100 hours (May need more often under
severe conditions.)
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Change the engine oil as shown in
Note:
Torque drain plug to 18 N∙m (13 ft-lb).
Figure 31
4. Slowly pour approximately 80% of the specified
oil into the filler tube, and slowly add the
additional oil to bring it to the Full mark
32).
Figure 31.
5. Start the engine and drive to a flat area.
6. Check the engine-oil level.
g025979
(Figure
32
Figure 32
g026005