Siemens SIMATIC RF600 System Manual page 86

RF600 system planning
4.7 Guidelines for electromagnetic compatibility (EMC)
Wide-area ground connection
● Plan a meshed grounding concept.
● Bond all passive metal parts to chassis ground, ensuring large-area and low-HF-
● Establish a large-area connection between the passive metal parts and the central
● Don't forget to include the shielding bus in the chassis ground system. That means the
● Aluminium parts are not suitable for ground connections.
Plan the cable installation
● Break the cabling down into cable groups and install these separately.
● Always route power cables, signal cables and HF cables through separated ducts or in
● Feed the cabling into the cabinet from one side only and, if possible, on one level only.
● Route the signal cables as close as possible to chassis surfaces.
● Twist the feed and return conductors of separately installed cables.
● Routing HF cables:
● Do not route cables through the antenna field.
Shielding for the cables
● Shield the data cables and connect the shield at both ends.
● Shield the analog cables and connect the shield at one end, e.g. on the drive unit.
● Always apply large-area connections between the cable shields and the shielding bus at
● Feed the connected shield through to the module without interruption.
● Use braided shields, not foil shields.
Line and signal filter
● Use only line filters with metal housings
● Connect the filter housing to the cabinet chassis using a large-area low-HF-impedance
● Never fix the filter housing to a painted surface.
● Fix the filter at the control cabinet inlet or in the direction of the source.
84
impedance contact.
grounding point.
actual shielding busbars must be connected to ground by large-area contact.
separate bundles.
avoid parallel routing of HF cables.
the cabinet inlet and make the contact with clamps.
connection.
System Manual, 05/2012, J31069-D0171-U001-A13-7618
SIMATIC RF600