Pioneer DV-610AV-S Service Manual page 35

5
NOTE
1. In case of the Clamper Ass'y installation, install correctly
as Fig. 2-5-B.
Plate Clamper
Clamper
2-6: HOLDER TRAVERSE/INSULATOR (F)/INSULATOR
(R) (Refer to Fig. 2-6-A)
1. Remove the Holder Traverse.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
Traverse Ass'y
Insulator (F)
Holder Traverse
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 2-6-B.
Insulator (F)
2-7: SWITCH PCB ASS'Y/GEAR MIDDLE/GEAR FEED/
RACK FEED ASS'Y/FEED MOTOR
(Refer to Fig. 2-7-A)
1. Unlock the support .
2. Remove the Gear Middle.
3. Remove the screw .
4. Remove the Rack Feed Ass'y.
5. Remove the screw .
6. Remove the Switch PCB Ass'y.
7. Remove the screw .
8. Remove the Gear Feed.
9. Remove the 2 screws .
10. Remove the Feed Motor.
11. Remove the Gear Motor.
5
6
Check Lock
Fig. 2-5-B
Pickup leneses
GEM1004
GED-008
Insulator (R)
Insulator (F)
Fig. 2-6-A
Traverse Holder
Fig. 2-6-B
DV-610AV-S
6
7
Gear Motor
Traverse Ass'y
Rack Feed Ass'y
±
• Screw Torque: 1.3 0.3 kgf•cm (Screw
±
• Screw Torque: 3.0 0.3 kgf•cm (Screw
±
• Screw Torque: 1.0 0.3 kgf•cm (Screw
NOTE
1. When installing the Rack Feed Ass'y, push both ends to
align the teeth as shown Fig. 2-7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 2-7-C is correct.
3. When installing the wire of the Switch PCB Ass'y, install
it correctly as Fig. 2-7-D.
Manual soldering conditions
• Soldering temperature: 320
• Soldering time: Within 3 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. After the assembly of the Traverse Ass'y, hook the wire
on the Traverse Ass'y as shown Fig. 2-7-E.
Rack Feed Ass'y
Push
[OK]
Gear Motor
Feed Motor
Safety surface for pressing
of the insert.
7
8
Feed Motor
Gear Feed
Gear Middle
Switch PCB Ass'y
)
)
, )
Fig. 2-7-A
±
20 °C
Push
[NG]
Fig. 2-7-B
±
8.0 0.2 mm
Fig. 2-7-C
35
8
A
B
C
D
E
F