Advertisement
Changing Configuration Settings for Time,
Date and Location
1. Press SET (D).
2. Follow steps 1 through 9 under Setting Time, Date,
and Location.
3. Press PROG (E), to return to main screen.
PROGRAMMING
This timer comes pre-programmed to turn ON at dusk and
OFF at dawn. If you wish to adjust this time to another ON/
OFF time, complete the programming steps in this section.
This timer only holds one set of ON/OFF times (either the
pre-programmed Dawn/Dusk times or the custom times you
program using the steps in this section).
Changing the Pre-Programmed Dusk (ON)
Time
To change the DUSK time to another ON time:
1. Press PROG (E) twice.
2. Turn the selector knob (H) until a time appears on the
screen. Press PROG (E).
3. Turn the selector knob (H) to select the correct ON hour.
Press PROG (E).
4. Turn the selector knob (H) for the correct ON minute.
Press SET (D). See FIG. 7.
Changing the Pre-Programmed Dawn
(OFF) Time
To change the dawn time to another OFF time:
1. Press PROG (E).
2. Turn the selector knob (H) until OFF is in the top left
corner of the screen. Press PROG (E).
3. Turn the selector knob (H) so that a time appears on the
screen. Press PROG (E).
4. Turn the selector knob (H) to select the correct OFF hour.
Press PROG (E).
5. Turn the selector knob (H) to select the correct OFF
minute. Press SET (D). See FIG. 8.
PERFORMING A FACTORY RESET
To clear any programming or reset the timer at any time,
perform these steps:
1. Press and continue to hold the ON/OFF button (F).
2. Using a paperclip, press and release the RESET
button (I).
3. Keep holding the ON/OFF button (F) until 'CLR'
appears on the screen, then release.
4. When you see 12:00 AM displayed, your timer is ready
for programming. See FIG. 9.
Digital Landscape Timer
FIG 7.
FIG 8.
Changing the Dawn (OFF) Time
FIG 9.
3
Changing the Dusk (ON) Time
Performing a Factory Reset
Advertisement
