Siemens SIMATIC FM 351 Getting Started page 6

Save the variable table VAT 1 with
Switch to online with
Switch to monitoring with
Caution
!
With the next two steps in the test you start the drive.
You can stop the drive again in one of the following ways:
Change the CPU to RUN-P.
With Variable > Activate Modify
The drive is started. In the "Modify Value" column, you can now monitor the current actual value
( of the position.
ACT_POS)
Diagnostics
Errors can occur due to incorrect operator input, incorrect wiring, or conflicting parameter settings.
How to analyze such errors and messages is described in Section 6.4 and Chapter 11 of the manual.
Example
The project zEn18_01_FMx51 contains further samples that you can use as a basis and adapt to your
application.
Siemens AG
Bereich Automatisierungs- und Antriebstechnik
Geschaeftsgebiet Industrie-Automatisierungssysteme
Postfach 4848, D-90327 Nuernberg
Siemens Aktiengesellschaft
Table >
PLC > Connect to > configured
Variable > Monitor.
Set the control value for the direction to 0 again and activate it
Set the control value for the drive enable to 0 again and activate it
Change the CPU to the STOP mode
Values, you make the modify values valid.
Save.
CPU.
Siemens AG 2000
Subject to change
C79000-Z7076-C354
Printed in the Fed. Rep. of Germany