Washing Programs - Smeg LSA4551B Instruction Manual

User instructions
TO CHANGE A PROGRAM
To change the running program it is necessary:
• to interrupt the running program (see "I
•
select the new program;
•
to press again the START/PAUSE button (4) to make start the new program.
ANNULLING A PROGRAM
To annul the program in progress, it must first be interrupted (see "I
In case that the door is opened during the operation, to the next door closing it is going to be
necessary to start the program as shown in paragraph "S
from the point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program will start about 30 seconds
later.
1.2

Washing programs

The dishwasher is equipped with a control panel, described in chapter "1. Description of the
controls", from which it is possible to carry out all the power switch-on, switch-off and programming
operations.
Before starting a washing program make sure that:
The water supply tap is open.
•
The correct amount of detergent has been added to the dispenser.
•
The baskets have been correctly loaded.
•
The spray arms are able to rotate freely and without obstruction.
•
The dishwasher door is securely closed.
•
DELAY PROGRAM (on some models only)
Pressing button DELAY PROGRAM (3) in sequence delays the start of the program by 3, 6 or 9
hours. This allows you to set the dishwasher to work at specific times of day.
After selecting the delay, start the program in the normal way (see relative section).
The appliance will prewash the dishes, after which the "delay program" set previously will come into
effect (the light corresponding to 3, 6 or 9 hours flashes).
To reset or change the delay once the program has started:
•
press the START/PAUSE button (4) for a few seconds, until the PROGRAM PHASES lights
(8) come on;
• press the DELAY PROGRAM button (3) several times "until the program delay" returns to zero
(all the lights indicating the delay go out);
•
press the START/PAUSE button (4) to start the new program.
NTERRUPTION OF A PROGRAM
Now press buttons P1+P2 simultaneously and the first three program
lights will come on.
");
NTERRUPTION OF A PROGRAM
". The program will resume
TART PROGRAM
").
15