Smeg LSA4551B Instruction Manual page 5

TABLE FOR CERTIFICATION BODIES
Reference standard
Reference program
Load
Type of detergent
Amount of detergent
Rinse aid setting
START PROGRAM
To start the dishwasher, press the START/PAUSE button (4) for a few seconds, until
the light of the first phase of the selected program starts to flash (confirmation beep).
As the program runs, the PHASES/PROGRAM lights (8) will indicate the current cycle
status:
Prewash
END PROGRAM
When the program finishes, a buzzer sounds briefly and all the
PROGRAM PHASES lights (8) flash. Press any of the SELECTION
PROGRAMS buttons (2), stops the light flashins, and the
dishwasher is now ready to perform a new cycle; opening and
shutting the door or switching the appliance off and on has the same
effect.
INTERRUPTION OF A PROGRAM
In order to interrupt a running program it is necessary:
•
•
14
User instructions
Wash
Rinse
Dry
press the START/PAUSE button (4), the light of the current phase goes out;
keep the button pressed until the PROGRAM PHASES lights (8) come on (confirmation
buzzer).
Depending on the model 3/4 or 4/6
The light of the phase in progress will flash, while
the lights of previous and subsequent phases remain on.
N.B. during execution of programs which do not
include a prewash, the first PHASES/PROGRAM light
(8) will remain off.
EN 50242
(*) ECO program
9 place-settings
B
30 g