Table of Contents
Advertisement
Water connections
a) Water inlet hose
The specific hoses that come with the
machine are connected to the water inlet
valves on the machine. Red labeled hose is
for hot water inlet and blue labeled hose is
for cold water inlet.
In order to prevent the water leakages that
may occur on the connection points, rubber
seals are placed on the hose or in the
package (4 pieces for the models with
double water inlets and 2 pieces for other
models). These gaskets should be used
for connections in both sides of the hose.
Gaskets on the machine side should fit in
the hose filter channel.
Since the connection points are under water
pressure, turn on the taps to the maximum
after the connection. Check if there is any
water leakage at the connection points. In
order to prevent the water leakages and the
damages they may cause, keep the taps
closed when you are not using the machine.
Minimum 1 bar and maximum 10 bars of
water flow from the tap is enough for your
machine to operate efficiently. (In practice,
1 bar means that more than 8 liters of water
per minute flows from a full open tap.)
Install the elbowed end of the hose to your
machine. Hand-tighten the nuts of the hose,
do not use a spanner
7
Models with double water inlets can be used
as a model with a single water inlet by using
a plug. Plug should be installed to the hot
water valve. A rubber gasket should be used
in order to prevent water leakage from the
connection point.
Do not connect the product with single
water inlet to the hot water tap. The product
may switch to the protection mode if the
temperature of the water connected to a
product with double water inlet through a Y
part and single water inlet is above 40°C.
a) Water drainage hose
Water drainage hose can be attached to the
side wall of a sink or bathtub. Hose should
not be bend. When the drainage hose is
hanged on a sink or bathtub, it can be
secured with a hose bracket so that it will
not fall.
The end of drainage hose can be
connected directly to the waste water
drainage hole or to the specific end that is
installed to the outlet elbow of the sink.
The hose should be installed to a height of
40 cm minimum and 100 cm maximum.
EN
7
Advertisement
Table of Contents
