CI-HSI-41, Configuration Worksheet:
"Standard Configuration" shown in Red
Headset Microphones:
Some headsets may be setup as only 'listeners'
Microphones are shut off at the Base Station
Microphone 1
ON
OFF
Microphone 2
ON
OFF
Microphone 3
ON
OFF
Microphone 4
ON
OFF
Headset BUSS AUDIO Sources: Summed
Headset #1, Microphone is always Summed
Headsets #2 thru #4, Microphones
ON
OFF
Headsets Microphone AUDIO: After ALC, Summed Audio
Always Active,
ALWAYS
Only when the Talk Switch is Active, TK-SW
Headset #1, Microphone Enabled:
ALWAYS
Only when the Talk Switch is Active, TK-SW
Headset #1, Listens to the CI-BUSSes:
Master Connector,
ON
OFF
Slave Connector,
ON
OFF
Headsets #2 thru #4, Listens to the CI-BUSSes:
Master Connector,
ON
OFF
Slave Connector,
ON
OFF
PA-BUSS Output Connector: Monitor/Communications
Signal Sources: Summed to Output
Audio Pair (Pins 4&5) carry Summed audio
Master IC-BUSS Connector, Could be more Headsets, etc
ON
OFF
Slave IC-BUSS Connector, Could be Operator Microphone
ON
OFF
Headset, After ALC, All the Headset Microphones summed
ON
OFF
Keyed/ALERTed when:
Logically OR'ed to Output (Pins 7&8)
The CI-BUSS is ALERTed
ON
OFF
Talk Switch is Active
ON
OFF
Always, other Jumpers Ignored
ON
OFF
Audio Output is present:
ALWAYS
When
KEYED
Slave IC-BUSS Connector: Could be Operator
Master IC-BUSS Connector, Could be more Headsets, etc
ON
OFF
Headset, After ALC, All the Headset Microphones summed
ON
OFF
Master IC-BUSS Connector: Could be another HSI-41
Slave IC-BUSS Connector, Could be Operator Microphone
ON
OFF
Headset, After ALC, All the Headset Microphones summed
ON
OFF
6/29/2017
Tech Works CI-HSI-41 Systems Planning & Installation Manual
All Headsets have their Microphone enabled at the their
respective base Stations
Headset 1 Microphone on the BUSSes
Headset Microphone Audio is Always available to the
BUSSes
Headsed1, Microphone always Enabled
Headset 1, listens to the Collaboration BUSSes
Headsets 2 thru 4 listen to the Collaboration BUSSes
The PA-Buss Monitor Output includes all
Audio Signal Sources
The PA-BUSS Output is always On
The Monitor Audio is keyed
However, it is always present (See Above)
All Audio Source are sent to the
Slave CI-BUSS Connector
All Audio Source are sent to the
Master CI-BUSS Connector
Page 11 of 13
Need help?
Do you have a question about the CI-HSI-41 and is the answer not in the manual?