Ge Mds P23 Protected Network (Redundant) Configuration; Ge Mds P23 Protected Network (Redundant) Config - GE MDS Mercury Series Reference Manual

8
The internal WiFi module has FCC modular approval and may only be
operated by connecting one of the GE MDS approved antennas (see
802.11 WiFi Module Specifications
nector on the radio's front panel. The WiFi module can operate as an
802.11 Access Point or Infrastructure Station, according to user config-
uration. The operational mode (
be configured through the unit's user interface.
Figure 1-2. Mercury Remote with Option Set 1 (MaxRM)
(Note interface connector differences from Standard Remote)
802.11 WiFi Module Specifications
The specifications listed below are unique to Remotes with Option 1
Set, which contain a 2.4 GHz WiFi module.
Page 176 contains a complete list of general Mercury Series specifica-
tions.
Protocol:
Frequency Range:
Maximum Transmit Power:
Permissible Antennas:
FCC:
FCC ID:
WiFi Antenna Connector:
1.2.3 GE MDS P23 Protected Network (Redundant)
Configuration
For mission-critical applications, a Protected Network Station is also
offered. This unit incorporates two Access Points, two power supplies,
and a switchover logic board that automatically selects between Trans-
ceiver A and Transceiver B as the active radio.
Mercury Reference Manual
below) to the reverse-SMA con-
AP, Infrastructure RM ) and frequency can
Invisible place holder
SPECIFICATIONS on
IEEE 802.11b/g OFDM 6 to 54Mbps, CCK 1 to
11Mbps
2400 to 2500MHz
15 dBm
PCTEL: BMLPV2400NGP
Sagrad: W1037
Sagrad: W1038
Part 15C
VRA-SG9011028
Female Reverse SMA
Figure 1-3 shows the
05-4446A01, Rev. D