Aluminum Foil - KitchenAid KOSE900HBS User Instructions

Aluminum Foil

IMPORTANT: To avoid permanent damage to the oven bottom
finish, do not line the oven bottom with any type of foil or liner.
For best cooking results, do not cover entire rack with foil
■
because air must be able to move freely.
To catch spills, place foil on rack below dish. Make sure foil is
■
at least 1/2" (1.3 cm) larger than the dish and that it is turned
up at the edges.
Oven Racks
IMPORTANT: To avoid permanent damage to the porcelain
finish, do not place food or bakeware directly on the oven door or
bottom.
Racks
Position racks before turning on the oven.
■
Do not position racks with bakeware on them.
■
Make sure racks are level.
■
To move a rack, pull it out to the stop position, raise the front
edge, then lift it out. Use the following illustration and charts
as guides.
NOTE: The SatinGlide™ Roll-Out Extension Rack for Smart Oven+
Attachments is inserted and removed the same way as a standard
rack, however, more force is needed.
Rack and Bakeware Positions
Rack Positions - Upper And Lower Oven
Broiling
Food
Most broiling
For hamburger patties to have a well-seared exterior and a rare
interior, use a flat rack in position 6. Side 1 should cook for
approximately 3 minutes. Side 2 should cook for approximately 3
to 4 minutes. Expect a moderate degree of smoke when broiling.
6
5
4
3
2
1
Rack Position
6
Traditional Cooking
Food
Large roasts, turkeys, angel
food, bundt cakes, quick
breads, pies
Yeast breads, casseroles,
meat and poultry
Cookies, biscuits, muffins,
cakes
Convection Cooking
Number of
Oven Setting
Racks Used
Rapid Preheat Bake 1
Rapid Preheat 1
Convection Bake
Convection Bake 1
Convection Bake 2
Convection Bake 3
Convection Roast 1
Convection Broil 1
Baking Cakes on 2 Racks
For best results when baking cakes on 2 racks, use the Bake
function and flat racks in positions 2 and 5. Place the cakes on the
racks as shown. Keep at least 2 inches of space between the front
of the racks and the front of the cakes.
Baking Cookies on 2 Racks
For best results when baking cookies on 2 racks, use the
Convect Bake function and place flat racks in positions 2 and 5.
Bakeware
To cook food evenly, hot air must be able to circulate. For best
results, allow 2" (5 cm) of space around bakeware and oven walls.
Use the following chart as a guide.
Number of Pan(s) Position on Rack
1 Center of rack
2 Side by side or slightly staggered
3 or 4 See the rack position graphics
in this section for pan placement
recommendations.
Rack Position
1 or 2
2
2 or 3 when single-rack baking;
2 and 5 when multi-rack baking
Rack Position(s)
3
3
1, 2, or 3
2 and 5
1, 3, and 5
1 or 2
4, 5, or 6
11