Advertisement
Application
The Dual Access Sling is designed to be used from a sitting position with either a
patient lifting hoist or a Standaid. The sling gives access to remove and refit lower
garments for toileting transfers whilst the client is supported by the sling. This sling
can make toileting less time consuming than if performing the manoeuvre with a
Universal Sling however the person must have the ability to maintain a 90 degree
position between their femur and pelvic girdle.
Please read all instructions in full, including
Sling Inspection
All Prism slings are manufactured to meet and exceed the requirements of
BS EN 10535:2006. Slings should be inspected prior to use and after washing.
Damaged or badly worn slings should be discarded.. The label on the sling contains
vital information to identify the sling—if any part of the label becomes illegible, then
it must be removed from service and replaced.
The sling should be visually inspected with regard to the following items:-
Any signs of damage (i.e. Cuts, frays, tears, burns) to the sling straps.
•
Any signs of stitching becoming undone on any part of the sling.
•
Any signs of the fabric being stretched, tearing or undue wear.
•
Any signs of discolouring or bleaching on the material.
•
Is the sling complete? i.e. All straps present, stiffeners in place - where
•
applicable, etc.
Label clearly legible.
•
Compatibility
The issue of sling compatibility with various manufacturers' hoists has been a con-
cern for specifiers for a number of years, an issue that is compounded by the in-
creased number of companies supplying hoists and slings.
Some hoist/sling manufacturers will state that only slings manufactured by them can
be used on their hoists and vice versa. This is their policy only and is NOT a legal
requirement. A risk assessment must still be completed even if the same manufac-
turer of hoist and sling are to be used, and the specifier simply has to state that the
carry bar is of a similar design and that the sling manufacturer has authorised its
use on it.
A comprehensive list is available separately and your local agent will be able to
provide assistance with compatibility issues.
Maximum Load (Safe Working Load - S.W.L)
The maximum load for the sling is clearly marked on the label of the sling. The
maximum load will also be displayed on the hoist and any detachable elements of
the hoisting system.
DO NOT exceed the maximum load stated on any of the equipment.
PL2 - Prism Dual Access User Guide - Doc 002 - Rev 04/2010
Prism Dual Access Sling
the back page, before you pro
Advertisement
