Installing The Handle - Makita DUR189 Instruction Manual

Installing the handle

Fit the handle onto the shaft and secure it with the bolt and the knob.
1
2
1. Handle 2. Bolt 3. Knob
5. Battery cartridge side
Make sure that the handle is located in the straight area
Installing the protector
WARNING:
Never use the tool without the
protector illustrated in place. Failure to do so can
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
1. Attach the protector and the protector holder to the
tions and grooves on them to their counter parts.
4
1
3
1. Protector 2. Groove 3.
3
4 5
Cutting tool side
-
3
2
Protector holder
10 ENGLISH
2. Tighten the hex socket head bolts securely to
fasten the protector and the protector holder.
1
2
1. Hex socket head bolt 2. Hex wrench
Installing the wire guard
CAUTION:
Before adjusting the wire guard,
wait for the cutting head comes to standstill. Do
not adjust the wire guard with your foot.
cutting head, insert the wire guard so that it controls the
cutting range of the mowing line.
Slightly expand the wire guard outward and then insert
it into the holes on the protector.
1. Wire guard 2. Hole (on both sides)
NOTICE:
Do not expand the wire guard outward too
much. Otherwise it may break.
2
1