Operating Instructions; Front Panel Controls And Indicators; Mon Volume; Mon. Sq - RF Technology Eclipse Series Operation And Maintenance Manual

1 OPERATING INSTRUCTIONS

Changes or modifications not expressly approved
by RF Technology could void your authority to operate this equipment.
Specifications may vary from those given in this document in accordance with
requirements of local authorities. RF Technology equipment is subject to
continual improvement and RF Technology reserves the right to change
performance and specification without further notice
1 Operating Instructions

1.1 Front Panel Controls and Indicators

1.1.1 Mon Volume

The Mon. Volume control is used to adjust the volume of the internal loudspeaker and any
external speaker connected to the test socket. It does not effect the level of the 600 Ohm line
or direct audio output.

1.1.2 Mon. SQ.

The Mon. SQ. switch allows the normal squelch functions controlling the monitor output to
be disabled. When the switch is in the Mon. SQ. position the audio at the monitor speaker is
controlled by the noise detector. The CTCSS, carrier and external squelch functions are
disabled. This can be useful when you are trying to trace the source of on-channel
interference or when setting the noise squelch threshold. the audio from the 600Ω line and
direct outputs is not effected by the switch position.
1.1.3 N.SQ
The N.SQ trimpot is used to set the noise squelch sensitivity. Use the following procedure
to set the noise squelch to maximum sensitivity.
1. Set the toggle switch to the Mon. Sq. position and set the Mon. Volume control to 9
o'clock.
2. Turn the N.SQ adjustment counter clockwise until the squelch opens and noise is heard
from the speaker. Adjust the volume to a comfortable listening level.
3. In the absence of any on channel signal, turn the NSQ screw clockwise until the noise in
the speaker is muted. Then turn the screw one additional turn in the clockwise direction.
___________________________________________________________________________
RF Technology R800
WARNING
.
Page 4