Rear Panel Connectors - RF Technology Eclipse Series Operation And Maintenance Manual

3 TRANSMITTER I/O CONNECTIONS
3.2 Rear Panel Connector s
The exciter and receiver can be supplied with optional rear panel connectors that bring
out the more important signals available on P1, the rear panel DB25 connector.
Figures 1 and 2 show the rear panel connectors, and Table 4 shows the signals that are brought
out to the spade connectors. The spade connectors (2.1x0.6x7mm) are captive/soldered
at the labelled points.
Fig 1
RX PCB
The Receiver and Transmitter modules plug into the back plane DB25/F connectors
To configure: Solder wire connections between appropriate points.
___________________________________________________________________________
RF Technology T800

3.2 Rear Panel Connectors

Fig 2
TX PCB
Page 11