Jenn-Air JWD7030CDX Service
  1. Manuals
  2. Brands
  3. Jenn-Air Manuals
  4. Warming Drawer
  5. JWD7030CDX
  6. Service
Jenn-Air JWD7030CDX Service

Jenn-Air JWD7030CDX Service

Hide thumbs Also See for JWD7030CDX:
Table of Contents

Advertisement

Quick Links

See also: User Manual , Installation Manual
Service
This manual is to be used by qualified appliance
technicians only. Maytag does not assume any
responsibility for property damage or personal
injury for improper service procedures done by
an unqualified person.
Warming
Drawer
This manual covers
technical service information.
This manual includes, but is
not limited to the following:
JWD7030CDX
JWD7130CDB
JWD7130CDK
JWD7130CDP
JWD7130CDS
JWD7130CDW
16021975
Revision 0
January 2003

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JWD7030CDX and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Jenn-Air JWD7030CDX

Summary of Contents for Jenn-Air JWD7030CDX

  • Page 1 Warming This manual covers technical service information. This manual includes, but is Drawer not limited to the following: JWD7030CDX JWD7130CDB JWD7130CDK JWD7130CDP JWD7130CDS JWD7130CDW 16021975 Revision 0 January 2003...

  • Page 2: Important Information

    Important Information Important Notices for Servicers and Consumers Maytag will not be responsible for personal injury or property damage from improper service procedures. Pride and workmanship go into every product to provide our customers with quality products. It is possible, however, that during its lifetime a product may require service.

  • Page 3: Table Of Contents

    Table of Contents Important Information ..........2 Disassembly Procedure Important Safety Information Unit Removal ............9 ALL APPLIANCES ..........4 Carriage Removal ............ 9 In Case of Fire ............4 Slide Removal ............9 Precautions ............4 Drawer Gasket ............9 Electrical Requirements ..........

  • Page 4: Important Safety Information

    Important Safety Information In Case of Fire CAUTION Fires can occur as a result of over cooking or excessive grease. Though a fire is unlikely, if one occurs, proceed To avoid personal injury, do not sit, stand or lean on as follows: drawer.

  • Page 5: Electrical Requirements

    Important Safety Information Electrical Requirements 120-volt, 60 Hertz, individual circuit which is properly grounded and protected by a circuit breaker or time delay fuse. Extension Cord Due to possible pinching during installation, extension cords should not be used on Built-in products. Grounding NOTE: This appliance must be properly grounded and polarized, for personal safety.

  • Page 6: General Information

    General Information Nomenclature Idenifier Jenn-Air Warming Color Drawer Feature B -Black Content 0=Most Units 1=Front W-White S -Stainless Size Unit Steel Series Dual P-Pro-Style K -Cabinet Listed Rating Plate Functional Operation Rating plate is located on the interior right side of unit Mechanical controllers provide operational control for a when the warming drawer is removed.

  • Page 7: Specifications

    Specifications Model JWD7030CDX Power Source Voltage rating 120 VAC Amperage rating circuit breaker or time delay fuse 15 or 20 Amp Frequency 60 Hz Element Bake 450 Watts Features Temperature control Knob Interior material Stainless Steel Drawer glides Smooth roller...

  • Page 8: Component Testing Procedures

    Component Testing Information WARNING To avoid risk of electrical shock, personal injury, or death, disconnect power to oven before servicing, unless testing requires it. Illustration Component Test Procedure Results Indicator light Remove one lead from terminal. 0 Ω Measure resistance across terminals Measure voltage at indicator light If voltage is present and light does not operate, replace light.

  • Page 9: Disassembly Procedure

    Disassembly Procedure To avoid risk of electrical shock, personal injury, or WARNING death, disconnect power to unit before servicing. Unit Removal Thermostat 1. Remove carriage from unit. 1. Remove unit from installation. 2. Remove screws securing front frame to cabinet. 2.

  • Page 10: Illustration Breakdown

    Disassembly Procedure To avoid risk of electrical shock, personal injury, or WARNING death, disconnect power to unit before servicing. Drawer Pan Slide-LH Rack Magnet Magnet Bracket Shoulder Vent Washer Screw Slide Split Washer Slide-RH Vent Slide Drawer Frame Screw Screw Exterior Cover Screw...

  • Page 11: Wiring Diagram And Schematic

    Wiring Diagram and Schematic To avoid risk of electrical shock, personal injury, or WARNING death, disconnect power to unit before servicing. 16021975 Rev. 0 ©2003 Maytag Appliances Company...
  • Page 12 Wiring Diagram and Schematic To avoid risk of electrical shock, personal injury, or WARNING death, disconnect power to unit before servicing. This page intentionally left blank. 16021975 Rev. 0 ©2003 Maytag Appliances Company...
  • Page 13 Appendix A A–1 16021975 Rev. 0 ©2003 Maytag Appliances Company...
  • Page 14 LECTRIC LECTRIC ARMING ARMING RAWER RAWER NSTALLATION NSTALLATION G U I D E G U I D E ABLE OF ONTENTS Before You Begin..............A-3-A-4 Specifications and Requirements ......... A-5-A-7 Form No. A/10/02 Part No. 8101P493-60 © 2002 Maytag Appliances Sales Co. Litho U.S.A .
  • Page 15 EFORE EGIN Read these instructions completely RODUCT IMENSIONS and carefully. " ProStyle Front " IMPORTANT: " Curved Front • Save these instructions for the local electrical inspector’s use. " 9" • OBSERVE ALL GOVERNING CODES AND ORDINANCES. " ProStyle Fronts 30"...
  • Page 16 • A properly grounded 3-prong receptacle IMPORTANT (Please read carefully) ROUNDING THE should be located within reach of the The power cord of this ap- PPLIANCE drawer’s 56” long power cord. pliance is equipped with IMPORTANT (Please read carefully) • Locate the receptacle in an adjacent cabi- a 3-prong (grounding) net.
  • Page 17 PECIFICATIONS AND EQUIREMENTS NSTALLING ELOW NOTE: If you are installing in frameless NSTALLING ELOW cabinets, it may be necessary to install 1/2" OUNTERTOP OOKTOP wide cleats to accept drawer mounting Drawer overlaps will conceal cut edges on Warming drawers are suitable for installa- screws.
  • Page 18 NSTALLING ELOW NSTALLATION ELOW A INGLE " *NOTE: Additional clearance between cutouts may Min. Warming drawers are suitable for installa- be required. Check to be sure that oven supports tion below only certain specified wall oven above the warming drawer location do not obstruct models.
  • Page 19 PECIFICATIONS AND EQUIREMENTS CONT ROVIDE ABINET RACE NSTALLING THE UPPORT RAWER WARNING 1. Slide the left corner into opening and IMPORTANT: When installed below a push power cord into the hole leading to single or double oven, check to be sure that •...
  • Page 20 Appendix B B–1 16021975 Rev. 0 ©2003 Maytag Appliances Company...
  • Page 21 LECTRIC ARMING RAWER LECTRIC ARMING RAWER G U I D E G U I D E ABLE OF ONTENTS Safety Instructions ..............B-3-B-5 Operating Instructions ............B-5-B-7 Care & Cleaning ................ B-8 Installation ................B - 9 -B-14 Before You Call for Service ........... B-15 Warranty ..................
  • Page 22 Do not leave children alone. Children should If you have questions, call: not be left alone or unattended in an area where an appliance is in use. They should Jenn-Air Customer Assistance WARNING never be allowed to sit or stand on any part 1-800-JENNAIR of the appliance.
  • Page 23 Always keep wooden and plastic utensils Use only dry pot holders. Moist or damp Use care when opening the drawer. Open and canned food a safe distance away from pot holders on hot surfaces may result in the drawer a crack and let hot air or steam your warming drawer.
  • Page 24 PERATING NSTRUCTIONS SING THE ARMING RAWER The warming drawer will keep hot, cooked Turn the control knob to the desired set- OISTURE ELECTOR foods at serving temperature. Always start ting. The moisture selector is lo- with hot food. cated on the inside front Do not use to heat cold food other than of the drawer.
  • Page 25 ERVING RISP TALE TEMS CAUTION • Place food in low sided dishes or pans. OWLS AND LATES • Dishes may be hot. Use pot holders • Preheat on LOW setting and open the • To warm serving bowls and plates set the or mitts when removing hot dishes.
  • Page 26 See your • Do not put water in the warming pan. temperature for the food needing the high- Jenn-Air dealer or call 1-800-JENNAIR. est setting. • Do not use plastic containers or plastic DRAWERPANS includes five commercial wrap.
  • Page 27 & C LEANING ARMING RAWER CAUTION Most cleaning can be done to the pan with • Clean the rack with detergent and wa- the pan in place in the drawer. However, ter. • Be sure appliance is off and all parts the pan may be removed if further cleaning are cool before handling or cleaning.
  • Page 28 NSTALLATION RODUCT IMENSIONS EFORE EGIN Read these instructions completely and carefully. IMPORTANT: • Save these instructions for the local electrical inspector’s use. 30" • OBSERVE ALL GOVERNING CODES AND ORDINANCES. NOTES: & M power cord in adjacent cabinet, within 42" OOLS ATERIALS TO INSTALLER:...
  • Page 29 • A properly grounded 3-prong receptacle IMPORTANT (Please read carefully) ROUNDING THE should be located within reach of the The power cord of this ap- PPLIANCE drawer’s 56” long power cord. pliance is equipped with IMPORTANT (Please read carefully) • Locate the receptacle in an adjacent cabi- a 3-prong (grounding) net.
  • Page 30 NSTALLATION CONT PECIFICATIONS AND EQUIREMENTS NOTE: If you are installing in frameless NSTALLING ELOW NSTALLING ELOW cabinets, it may be necessary to install 1/2" OUNTERTOP OOKTOP wide cleats to accept drawer mounting Drawer overlaps will conceal cut edges on Warming drawers are suitable for installa- screws.
  • Page 31 NSTALLING ELOW NSTALLATION ELOW A INGLE *NOTE: Additional clearance between cutouts Warming drawers are suitable for installa- may be required. Check to be sure that oven tion below only certain specified wall oven supports above the warming drawer location models. do not obstruct the required interior 23 "...
  • Page 32 NSTALLATION CONT • A 2" minimum clearance between oven ROVIDE ABINET RACE and warming drawer cutouts is required. UPPORT Additional clearance may be required if WARNING 2" x 4" blocks are used to support run- IMPORTANT: When installed below a ners or solid floor of the oven above.
  • Page 33 NSTALLING THE RAWER 1. Slide the left corner into opening and push power cord into the hole leading to the outlet location. Thread the cord through as drawer is being pushed back into the opening. If the outlet is installed inside the open- ing, plug the cord into the outlet.
  • Page 34 EFORE ALL FOR ERVICE Problem Possible Causes What To Do Warming drawer will not work A fuse in your home may be Replace the fuse or reset the circuit breaker. blown or the circuit breaker tripped. ○ ○ ○ ○ ○...
  • Page 35 OTES B-16...
  • Page 36 • Call the dealer from whom your appliance was purchased or call Maytag and Canada - Parts Only Appliances Sales Company, Jenn-Air Customer Assistance at 1-800- For two (2) years from the date of original retail JENNAIR (1-800-536-6247) to locate an authorized servicer.

This manual is also suitable for:

Jwd7130cdbJwd7130cdkJwd7130cdpJwd7130cdsJwd7130cdw

Table of Contents