CEL-FI GO Mobile Quick Start Manual page 2

Cel-Fi GO Mobile Installation
I
Install Donor Antenna
DONOR ANTENNA (Not Included)
Mount your Donor Antenna on the exterior of the vehicle,
towards the rear, according to its design, and the type of
vehicle it's being used with. Make sure you consider the
cable connection to the Cel‑Fi GO unit with your location
choice.
For best performance make sure
there is 50cm of metal around the
base of the antenna.
2
Install Service Antenna
DONOR ANTENNA
Install Service Antenna in the cab, towards the front,
where coverage is needed. Ideally, there should be
substantial material, like the metal of the roof, between
the Donor and Service Antennas, to improve isolation.
Cel-Fi GO Mobile Smart Signal Booster
3
CEL-FI GO
OPTIONAL
LOCATION
4
SERVICE ANTENNA
(Not Included)
Donor Antenna
RIGHT SIDE:
Connector
Mount Cel-Fi GO
DONOR ANTENNA
SERVICE
CEL-FI GO ANTENNA
Find a good mounting location in your vehicle. Location
should have airflow and be secure from contact with external
objects.
Make sure the unit is within cable range of the 12V power
supply on your vehicle.
Best to make sure all cable lengths support the intended
mounting location BEFORE permanent mounting.
DO NOT plug in at this time.
Connect Donor & Service Antennas
to the Cel-Fi GO Unit
DONOR ANTENNA
SERVICE
CEL-FI GO
ANTENNA
STATUS
INDICATOR
MODE
TOP VIEW
Service Antenna
LEFT SIDE:
Connector
5
Plug in Cel-Fi GO & Select Mode
DONOR ANTENNA
CEL-FI GO
STATUS
MODE INDICATOR
AUTO
3G
4G LTE
Boosting 3G
STATUS
Boosting 4G LTE
INDICATOR
Error*
(*NOTE: if Error, go to troubleshooting
at cel-fi.com/support)
Press the MODE button on the unit to select
desired scanning mode. Status Indicator will blink
during the setup process, and may take a few
minutes to complete.
(OPTIONAL: use your smartphone
to select mode. Download the Cel‑Fi
WAVE app, and follow the on-screen
NETWORK STRENGTH
instructions.)
12V POWER SUPPLY
SERVICE
ANTENNA
MODE
SELECT
BUTTON
www.cel-fi.com