Brother ScanNCut DX Stamp Starter Kit Operation Manual page 4

f
Peel the stamp sheet off the mat, and then check that the
test pattern has been cut out.
g
Touch the "Start" key to start cutting the stamp pattern.
h
Peel the backing from the cut-out stamp sheet.
i
After flipping over the cut-out stamp sheet, place it on the
acrylic block, arranging the pattern with the grid on the
block as a guide.
Note
• When placing characters or non-symmetrical patterns on
the acrylic block, be sure to flip them over before placing
them on the block.
j
Using the ink, color the stamp pattern.
k
Apply the stamp at the desired location.
Note
• After use, wipe off the ink on the cut-out stamp sheet and
acrylic block with a damp cloth or tissue, and then store
them after they have dried.
• When the leftover stamp sheet is used, it may curl up in the
machine. After cutting out the pattern, use scissors to cut
around the pattern to clean it up.
4