raycop VCEN-100 Operating Manual page 13

■Maintenance of the Pulsating Brush
If too much hair or debris is caught on the Pulsating Brush,
the Pulsating Brush may not function and will automatically
stop for safety reasons.
(The brush will automatically start rotating again about 3 seconds
after it stops.) Periodically remove any hair or obstacles on
the Pulsating Brush to ensure it operates correctly.
1
Slide the 2 grille hooks at both ends until you see the green indicator.
Green Indicator
2
Remove the Pulsating Brush by
lifting the end cap.
4
After cleaning, reattach the brush
to its original position from the left
side.
Caution
· The Pulsating Brush may be damaged if you try to forcibly remove hairs with scissors
or other sharp items, lowering performance and/or damage fabric surfaces.
· Please ensure the pulsating brush is completely dry before use.
Any residual water could impact the the functionality and effectiveness of RAYCOP to
sanitize your fabric.
Please make sure it is unplugged and
Warning
the power is turned off before cleaning or replacing.
Grille Hook
3
End Cap
5
Detach the end cap and remove any
hair that is entangled in the Pulsating
Brush. If the brush is excessively dirty,
wash it with detergent or soap, rinse
with water, and thoroughly dry.
Lock the hook securely by reversing
the procedure used for removal.
13