Delsys TRIGNO User Manual page 6

FCC ID: W4P-SP-W03 (Trigno Body Worn Receiver)
FCC ID: W4P-SP-W01 (Trigno Sensor)
IC: 8138A-DST02 (Trigno Personal Monitor System)
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference. and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
This product complies with FCC OET Bulletin 65 radiation ex-
posure limits set forth for an uncontrolled environment.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference. and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
Pursuant to Part 15.21 of the FCC Rules, any changes or modi-
fications to this product not expressly approved by Delsys Inc.
might cause harmful interference and void the FCC authoriza-
tion to operate this product.
To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotro-
pically radiated power (EIRP) is not more than that required for
successful communication.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency en-
ergy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
There is no guarantee that interference,will not occur in a par-
ticular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into outlet on a separate circuit.
6