Delsys TRIGNO User Manual page 11

Getting Started with the Personal Monitor
Charging the Trigno Sensors
Connect the Trigno power supply to the circular DC jack located
on the side of the Recharge Station. Energize the power supply by
connecting it to a Mains outlet. Be sure to use the appropriate plug
adapter for your locations (Figure XX). Ensure that the Trigno sen-
sors are properly fitted in the recharge pockets. The sensor LEDs will
illuminate to amber during charging and green when charge is com-
plete. The recharge unit will periodically check sensors and apply a
top-off charge to ensure that the battery kept at full capacity during
extended periods of storage, as long as power is connected.
Charging the Personal Monitor
Connect the Personal Monitor power supply to the DC jack locat-
ed on the bottom side of the device. Energize the power supply by
connecting it to a Mains outlet. Be sure to use the appropriate plug
adapter for your locations (Figure XX). Alternatively the Personal
Monitor can be charged via the USB port, by connecting it to a host
device.
Checking Sensor Status
From the home screen, select the "Sensors" button to display the sta-
tus of all active sensors. The status shows sensor charge status, channel
number, sensor type, network status and wireless signal strength. Sen-
sors can be paired from this screen, or turned off. Use the scroll arrows
to navigate the display as needed.
Figure 4.
11
Checking the sensor status on the TPM.
Trigno Personal Monitor User's Guide
TM