Windshield Wipers - Mercedes-Benz GLA 250 2019 Operator's Manual

Tail lamps
Loosen screws = using a screwdriver.
X
Remove the bulb holder from the tail lamp.
X
Bulb holder
Turn signals
?
Brake lamp
A
Turn signal: press the bulb gently into the
X
bulb holder, turn it counter-clockwise and
remove it from the bulb holder.
Insert the new bulb into the bulb holder and
X
turn it clockwise.
Brake lamp: remove the corresponding
X
bulb from the bulb holder.
Insert the new bulb into the bulb holder.
X
Insert the bulb holder into the tail lamp and
X
screw it firmly into place using screws =.
Insert the tail lamp into the vehicle.
X
Tighten fender nut : and re-establish con-
X
tact with connector ;.
Close the side trim panel (
X
!
!
Combination switch
1
2
3
4
5
B
X
page 108).
Y
X
!

Windshield wipers

Windshield wipers
Switching the windshield wipers
on/off
Do not operate the windshield wipers
when the windshield is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windshield can
scratch the glass if wiping takes place when
the windshield is dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always use
washer fluid when operating the windshield
wipers.
If the windshield wipers leave smears on
the windshield after the vehicle has been
washed in an automatic car wash, wax or
other residues may be the reason for this.
Clean the windshield using washer fluid
after washing the vehicle in an automatic
car wash.
$ Windshield wiper off
Ä Intermittent wipe, low (rain sensor
set to low sensitivity)
Å Intermittent wipe, high (rain sensor
set to high sensitivity)
° Continuous wipe, slow
¯ Continuous wipe, fast
í Single wipe/î Wipes the wind-
shield using washer fluid
Switch on the ignition.
Turn the combination switch to the corre-
sponding position.
Vehicles with a rain sensor: if the wind-
shield becomes dirty in dry weather condi-
tions, the windshield wipers may be activa-
ted inadvertently. This could then damage
109
Z