Mercedes-Benz C-Class Coupe 2019 Operator's Manual page 405

Removing and installing hub caps
Requirements:
The vehicle is prepared for a wheel change
R
( page 402).
/
Plastic hub cap
To remove: turn the center cover of the hub
#
cap counter-clockwise and remove the hub
cap.
To install: make sure that the center cover of
#
the hub cap is turned counter-clockwise.
Position the hub cap and turn the center
#
cover clockwise until the hub cap engages
physically and audibly.
Aluminum hub cap
To remove: position socket
#
1.
% The socket can be found in the tire-change
tool kit.
Position wheel wrench 3
#
Using wheel wrench 3, turn hub cap
#
counter-clockwise and remove it.
To install: position hub cap
#
it is completely flush with the wheel.
Position socket 2 on hub cap 1.
#
Attach wheel wrench
#
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
Raising the vehicle when changing a wheel
Requirements:
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
R
change (
The hub caps have been removed
2 on hub cap R
(
/
Important notes on using the jack:
Use only the vehicle-specific jack that has
R
been tested and approved by Mercedes-Benz
on socket 2.
to raise the vehicle.
1
The jack is only designed for raising and
R
holding the vehicle for a short time while a
1 and turn until
wheel is being changed and not for mainte‐
nance work under the vehicle.
Wheels and tires 403
3 to socket 2
page 402).
/
page 403).
and