Napoleon Acies l38 Series Installation Manual page 27

Before framing your appliance, determine vent requirements before deciding the final location of the appliance.
After rough framing, place the appliance in its final position.
single-sided
J
minimum framing
Ref
E
F
J
*L
see-thru
minimum framing
Ref
E 16 3/16" (41.1cm)
53 13/16" (136.7cm)
F
J Optional - Appliance does not need to be elevated above floor
73" (185.4cm)
*L
rough framing - before appliance installation
L
E F
L38
17 15/16" (45.6cm)
53 13/16" (136.7cm)
Optional - Appliance does not need to be elevated above floor
73" (185.4cm)
L
E
F
J
L38
note:
Before framing the appliance, ensure to install the
firestop first.
note:
The L series requires a minimum en-
closure height of 73" measured from
the bottom of the appliance. For tem-
perature requirements, this area must
be left unobstructed. Some venting
configurations that require more verti-
cal rise will require a larger enclosure
to provide minimum vertical clearance
between vent pipes and combus-
tibles. It is also recommended that the
enclosure be ventilated at the top and
bottom to circulate the hot air.
L50
17 15/16" (45.6cm)
65 13/16" (167.2cm)
73" (185.4cm)
note:
Before framing the appliance, ensure to install the
firestop first as it will not fit between the studs if
installed after framing.
note:
The L series requires a minimum en-
closure height of 73" measured from
the bottom of the appliance. For tem-
perature requirements, this area must
be left unobstructed. Some venting
configurations that require more verti-
cal rise will require a larger enclosure
to provide minimum vertical clearance
between vent pipes and combus-
tibles. It is also recommended that the
enclosure be ventilated at the top and
bottom to circulate the hot air.
L50
16 3/16" (41.1cm)
65 13/16" (167.2cm)
73" (185.4cm)
* Minimum enclosure
height maybe higher de-
pending on venting con-
figuration (see minimum
distance to combustibles).
W415-1707 / B / 06.04.18
EN
27