Page 1
P-2000 Version 2.0 PAPER MOISTURE METER OPERATION MANUAL DELMHORST EUROPE TITANIUMLAAN 100 NL 5221 CK ‘s-HERTOGENBOSCH THE NETHERLANDS info@delmhorst.eu www.MoistureMetersDelmhorst.com +31 (0)73 6395080...
Model P-2000 Owners Manual TABLE OF CONTENTS P-2000 Features Button Functions Check Calibration To Set the Scale To Change the Set-Point Information about Your Readings To Check the Accumulated Readings To Reset the Meter Applications Using the 0-1 00 Arbitrary Scale...
Continued use with a low battery may cause the meter to go out of calibration. lf you have a fresh battery and the instrument still does not indicate an acceptable calibration, return it to DELMHORST EUROPE for service. See "Service for Your Meter" section.
TO SET THE SCALE Set the scale to # 1 for most paper and paper products, # 2 for obtaining relative moisture indications on hygroscopic materials for which no established calibration is available, or # 3 for baled scrap paper. To change the scale, press and hold the scale button (#4).
TO CHECK THE ACCUMULATED READINGS This feature displays the total number of all accumulated readings for the given material you have chosen, the average of those readings, and the highest stored reading. To view the readings, press and release the calibration check button (#2). First the meter ...
USING THE 0 -100 ARBITRARY SCALE This scale is used to test the moisture content of hygroscopic materials for which a calibration is not available. Depending on the material, a special application external electrode, instead of the integral contact pins may be required. Increasing readings on the 0-100 reference scale indicate higher levels of moisture content.
CARE OF YOUR METER To keep your meter in good working order: Store your meter in a clean, dry place. The protective carrying case provided is an ideal storage place when the meter is not in use. Change the 9-Volt battery as needed. Continued use with a low battery may cause the meter to go ...
DELMHORST shall in no event be liable for any breach of warranty or defect in this product that exceeds the amount of purchase of this product. The express warranty set forth above constitutes the entire warranty with respect to Delmhorst meters and electrodes and no other warranty, written, oral, or implied applies.
Page 9
DECLARATION OF CONFORMITY Manufacturer's Name: Delmhorst Instrument Co. Manufacturer's Address: 51 Indian Lane East Towaco, NJ 07082 Council Directive(s): 89/336/EEC - Meets EMC directive 73/23/EEC - Not required. Voltage used or generated is not within scope of Low Voltage Directive.