SMC Networks barricade SMCWBR14-G2 User Manual page 24

I
NSTALLATION
LED
LAN 1~4
The following figure and table shows the rear panel of the Barricade.
9V
Power
Connector
Figure 2-2. Rear Panel
Item
Power Inlet
WAN Port
LAN Ports
Reset Button
Antenna
2-4
Status
On
Flashing
Off
1A WAN LAN4
RJ-45
Port
Description
Connect the included power adapter to this inlet.
Warning: Using the wrong type of power adapter may cause
damage.
WAN port (RJ-45). Connect your WAN line to this port.
Fast Ethernet ports (RJ-45). Connect devices on your local
area network to these ports (i.e., a PC, hub, switch or IP set
top box).
Use this button to reset the power and restore the default
factory settings. To reset without losing configuration settings,
see "Reset" on page 4-60.
Fixed antenna is connected here.
Description
Ethernet link.
The LAN port is sending or receiving data.
No Ethernet link.
LAN3 LAN2 LAN1
RJ-45 LAN Ports
Reset
Antenna
Button