Pack Contents; Installation; Fit Glass Panels - Polar Electro G608 Instruction Manual

Telephone Helpline: 0845 146 2887 (United Kingdom)

Pack Contents

The following is included:
• POLAR Refrigerator
• Top glass panel
• Rear glass panel
• Side glass panels x 2
• Instruction manual
• Collars x 6
POLAR prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your POLAR dealer immediately.

Installation

Note: If the unit has not been stored or moved in an upright position, let it stand upright for approximately 12 hours before
operation. If in doubt allow to stand.
Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.
1.
Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
2.
Note: Before using the appliance for the first time, clean the shelves and interior with soapy water.
Level the appliance by adjusting the screw feet.
3.

Fit Glass Panels

Screw the collars to the rim of the appliance.
1.
Note: Ensure the hole in the collar for the grub screw faces inwards.
Slot the two side panels into the collars, with the holes in the glass at the top.
2.
Note: Ensure the screw hole furthest from the edge of the panel goes to the back of the appliance.
Screw a grub screw into each collar to secure the panels.
3.
Note: Ensure the soft end of the grub screw is the end making contact with the glass.
Slot the rear panel into the collars, with the holes in the glass at the top.
4.
Screw a grub screw into each collar to secure the panel.
5.
Slot the plastic plugs into each of the holes.
6.
Screw the brackets to the inside of each pane using the bolt assemblies.
7.
Note: Ensure the short end of the bolt assembly is on the outside of the panels.
Place the top panel onto the brackets, ensuring all holes line up.
8.
Insert the plugs and attach the top panel to the brackets with the bolt assemblies.
9.
Bracket
Glass Panel
Bolt Assembly
Plug
• Brackets x 7
• Grub screws x 7
• Screws x 12
• Plugs x 14
• Gastranorm spacer bar
• Adjustable feet x 4
2