Fujitsu LifeBook N Series User Manual page 48

L i f e B o o k N S e r i e s U s e r ' s G u i d e
Problem
Shutdown and Startup Problems
The Power and
Suspend/Resume
button does not
work.
The system
powers up and
displays power-
on information,
but fails to load
the operating
system.
Your system
display won't
turn on when the
system is turned
on or when the
system has
resumed.
40
Possible Cause
The Power and
Suspend/Resume
button is disabled
from the Power ->
Advanced submenu of
the setup utility.
You did not hold the
button in long
enough.
There may be a
conflict with the
application software.
The boot sequence
settings of the setup
utility are not compat-
ible with your
configuration.
You have a secured
system requiring a
password to load your
operating system.
Internal hard drive
was not detected.
The system may be
password-protected.
Possible Solutions
Enable the button from the setup utility.
Hold the button longer. This may need to
be a few seconds if your application is
preventing the CPU from checking for
button pushes.
Close all applications and try the button
again.
Set the operating source by pressing the
[ESC] key while the Fujitsu logo is on
screen or use the [F2] key and enter the
setup utility and adjust the source settings
from the Boot menu.
Make sure you have the right password.
Enter the setup utility and verify the Secu-
rity settings and modify them accordingly.
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to
try to auto detect the internal hard drive.
Check the status indicator panel to verify
that the Security icon is blinking. If it is
blinking, enter your password.