Replacing The Battery - Fujitsu LifeBook N Series User Manual

L i f e B o o k N S e r i e s U s e r ' s G u i d e
provided power, you will need to press the
Suspend/Resume button to resume opera-
tion. In the Dead Battery Suspend mode,
your data can be maintained for some
time, but if a power source is not provided
promptly, the Power indicator will stop
flashing and go out, meaning that you have
lost the data that was not stored. Once you
provide power, you can continue to use
your LifeBook notebook while the adapter
is charging the battery.
Shorted Batteries
The Status Indicator panel displays the
battery status via the Battery Status indi-
cator to show the charge level available in
that battery. If the display is flashing red, it
means that the battery is damaged and
must be replaced so it does not damage any
other parts of your LifeBook notebook.

REPLACING THE BATTERY

With the purchase of an additional battery,
you can have a fully charged spare to swap
with one that is not charged.
Follow the steps below to replace a battery
(Figure 4-1):
1. Have a charged battery ready to install.
2. Shut down your notebook and discon-
nect the AC adapter.
3. Turn the system over.
4. Slide the battery release latch to the
right.
5. Lift the battery and remove it from the
bay.
20
Figure 4-1. Removing the Battery
6. Place a charged battery into the bay
and press it down until the latches click
into place.
7. Plug in the AC adapter and turn the
power on.
Figure 4-2. Installing the Battery