Table of Contents
Advertisement
2
CAUTION
Oil, grease or dirt must not
be allowed to enter the
internals of the machine.
General
2.1 Identification
The body number of the machine is shown on the body number
label, attached to the machine.
Body numbers are also stamped along one of the compressor body
corners/ edges next to the 'T' (Tested) stamp.
The suction/delivery ports and the direction of rotation are clearly
marked to permit the orientation to be identified.
2.2 Precautions
The exterior of the machine and ancillaries should be
steam cleaned prior to removal from the vehicle and /or
before commencement of any dismantling.
All mating parts should be marked during dismantling
to ensure correct re-assembly.
2.3 Inspection (prior to servicing)
Excessive radial movement of the machine drive shaft
indicates bearing wear, with the result that the rotor may
have damaged the bore of the body or the faces of the
side plates. If this is the case, the machine should be
returned to the Gardner Denver Drum representatives
for examination and possible refurbishing.
See installation, operating & maintenance
instructions to check the blade wear status.
Page
4
Hide quick links:
Advertisement
Table of Contents
