Table of Contents
Advertisement
NOTE
Make sure that the fans rotate
360˚and are not catching on
any other part of the
machine.
Sideplate Assemblies
See section 6 for the clearance setting procedure before proceeding further.
6. Once the shimming is complete remove the bearing housing cap,
pack with grease and refit.
7. Place anew star tolerance ring onto the shaft and lightly coat the
diameter with copper slip to aid future separation.
8. Place the fan onto the shaft & press the fan over the star tolerance ring
until it is fully located using a tubular dolly. See fig 13.
9. Repeat, for the opposite end (if required).
Figure 13. Fitting the fan(s )using a dolly.
10.Refit the cowls, mounting feet and drive flange /coupling.(reversal of
section 4.2)
Page
14
Hide quick links:
Advertisement
Table of Contents
