Installation - HOSSEVEN HDU-5 Instruction Manual

4. INSTALLATION

Remove stove from its packaging by holding its sides. Drill flue hole of your Hoşseven natural
gas stove according to wall mounts scheme as shown in Figure 9. Drill screw holes and insert
dowels on condition that measures will be taken into account in the same way. Ensure that the
wall, where installation to be done, is heat resistant or necessary isolations are done in order to
make it resistant, due to rear body of the stove will be heated during combustion.
To remove body completely by removing screws on the each side of device. Replace exhaust
gas pipe to the combustion chamber by fixing with screws and mount it with 4 screws as shown
in Figure 7.
Hermetic kit must be installed as 3% inclined downwards.
Figure 4: Flue installation slope
The distance between gas outlet and external wall surface must be at most 5 cm. Please
note this distance. Gas outlet pipe of your stove is telescopic; make distance adjustment
according to this standard size.
Reinstall body to its place, after make necessary connections and tests.
5. VENTED STOVE FEATURES
It is used by connecting flue in its environment. Gas connection is located outside of the
stove, it is not necessary to dismantle any part for connection. It is connected to flue by using ø
13cm pipe thanks to adaptor provided with your stove. Special flue safety system completely
turn-off your stove, when flue draught is insufficient or backlash of flue. It prevents the
spreading of flue gas to the environment. It burns its fuel in high efficiency and with blue flame.
It is easy to use due to superior gas control system. Due to Piezo igniter system, it is ignited
easily by only pressing lighter button.
It is pilot light safety. In case of extinguishing flame, it has a magnet valve safety system,
which cuts gas automatically. It has minimum and maximum combustion setting to provide fuel
savings. The efficiency is increased due to the special design of combustion chamber. The
7