Exchanging The Electronics; How To Proceed If A Repair Is Necessary - Siemens SITRANS LVL200S Operating Instructions Manual

Error
Signal lamp flashes red
Reaction after fault recti-
fication
22
Reason
Error on the vibrating element
Interference on the electronics mod-
ule
instrument defective
Depending on the reason for the fault and the measures taken, the
steps described in chapter "Set up" may have to be carried out again.
7.3

Exchanging the electronics

If the electronics module is defective, it can be replaced by the user.
In Ex applications only an electronics module with respective Ex ap-
proval may be used.
You can find all the information you need to carry out an electronics
exchange in the handbook of the new electronics module.
In general, all electronics modules of series SW60 can be inter-
changed. If you want to use an electronics module with a different
signal output, you carry out the complete setup. You find the neces-
sary, suitable operating instruction on our homepage.
Note:
Keep in mind that enamelled instrument versions need special
electronics modules. These electronics modules are called SW60E or
SW60E1.
7.4

How to proceed if a repair is necessary

If it is necessary to repair the instrument, please contact Siemens
Milltronics Process Instruments Inc. You find the locations on our
homepage "www.siemens.com/processautomation".
SITRANS LVL200S - Operating Instructions
Removal
Check if the vibrating element is
damaged or extremely corroded.
Exchanging the electronics module
Exchange the instrument or send it
in for repair
*7ML19985KS01*