If The Fireplace Does Not Light - Heat & Glo FDN-5-PIER Installation And Operating Manual

STOP! Read safety information on previous page and front cover of this manual before continuing.
NOTE: This fireplace is equipped with an ignition device which automatically lights the pilot.
DO NOT try to light the pilot by hand.
B. IF THE FIREPLACE DOES NOT LIGHT
1. Turn off the fireplace at switch.
2. Turn off all electrical power to fireplace.
3. Wait five (5) minutes to allow any gas that may have accumulated
inside firebox to escape. If you then smell gas, STOP! Follow safety
information on front cover and on previous page of the installation
manual. If you don't smell gas, go to next step.
4. Turn ON all electrical power to fireplace.
5. Turn fireplace on at switch.
CAUTION: If fireplace will not operate, follow instructions TURNING OFF GAS TO FIREPLACE and call your service
technician or the gas supplier.
NOTE: When fireplace is initially lit, condensation will appear on the glass; this is normal in all gas fireplaces and will
disappear after several minutes.
Heat & Glo • FDN-4-PIER, FDN-5-PIER, FDN-6-PIER, FDN-7-PIER Installation Manual • 16400-9803 • 2/19
36
11 - LIGHTING & SHUTDOWN
Figure 11B
2
OFF
5
ON